ep

January 20, 2021

Power UNITS FOR LIFT TABLE 1
Basic Description
This power unit is developed exclusively for the smaller lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit continues to be extensively applied within the sector of logistic units for instance minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed by the solenoid valve with all the pace controlled through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Standard Description
This electrical power unit is designed exclusively to the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve and the pace managed by the adjustable needle valve. Once the lift rises to a higher positoin, however the power provide is minimize, the decreasing movement is managed by the guide override function.
Power UNITS FOR LIFT TABLE 3
Common Description
This electrical power unit is designed exclusively for the huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve and the speed controlled by a stress compensated flow control valve.
Electrical power UNITS FOR LIFT TABLE four
Standard Description
This power unit is intended solely for the huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and the velocity controlled through the adjustable needle valve. When the lift rises to a higher positoin, but the power provide is reduce, the lowering motion is controlled from the manual override function.
Exclusive Notes
one. This power unit is of S3 duty cycle, which may only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic parts concerned before installation of the power unit.
three. Viscosity of your oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is advisable.
4. Oil modifying is needed soon after the original 100 operation hours,afterwards when each and every 3000 hrs.
5. The electrical power unit shown is intended to be mounted vertically.